There are two types of shirt buttons, one to two holes and the four holes (the most common), you may need to know how they stick, you never know, here you are a few simple steps.
For one thing you have to choose the button which must be equal, of course, to the other already sewn and the cotton thread to sew the color also in this case the same as the one already used for the other buttons.
Threading twice and make sure that the length of the two leaders on both sides is equal (20 / 25cm), tie a knot at the ends.
Align the button sewing to those already present and check the good correspondence of the slot, insert the needle previously prepared with the thread, first in the tissue and then let it pass for one of the holes of the button, pull around the wire every time and, in this first case until the node will not make resistance.
Repeat on the contrary that from the outside of the button through the Grim free hole into the fabric.
If the button sewing is four holes you choose the parallel hole and takes the process a few times and then move on to parallel holes in the face.
After you have completed this process five / six times you pass a ride just passing the fabric without thread the hole of the button and it wraps around itself 5/6 times the thread in the space between the button and the fabric.
We return with the needle in the fabric and give 2/3 reinforcement stitches at the seam underneath, we're done now we cut the wire in excess and we hope ...... we pass a bit of time before repeating this operation.
